Impulse 463E Uživatelský manuál stáhnout pdf (Strana 22)

- 19 -

SeaI/O User Manual

Step 2

On the front right side of the module, wedge a

slotted screwdriver between the top and bottom

halves as shown. Pry upwards – a pem in the top

half must clear the metal lip in the bottom half of

the enclosure.

Step 3

Remove the two screws from the metal strain

relief, as shown.

Step 4

Remove the three screws from the bottom of the

module and remove the front plate.

Step 5

Install up to four industry standard ribbon cables

in the 50-pin header connectors. A list of optional

cable part numbers is listed on the previous page.

Step 6

Replace the front plate and install the three screws

in the bottom of the module as shown.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 108 109

Žádné komentáře

Impulse 463E Uživatelský manuál Strana 22