Impulse W10I93S-PMH1HM Uživatelský manuál

1HMI Series Panel PCIntel Atom Z Series 3.5” SBC, Low Power, HighPerformance Design with Intel Atom Z SeriesPlatform, TFT LCD and 10/100/1000 base-TEt

101-2 I931 SBC and Atom Z5xx series Panel PC System SpecificationsCPU TypeIntel Atom Z series ProcessorCPU Speed1.1GHz/1.6GHzCPU FSB533MHzChipsetIntel

111-3 LCD Selection GuideThe HMI series Panel PCs support form 5.7-inch, 7-inch, 10.1-iinch TFT Panel w/touchscreen function, please refer the below:1

12Chapter 2 Getting Started2-1 Input / Output DevicesThe following figure shows the I/O arrangement of the Panel PC. The backside of the chassisc

132-2 Starting the Panel PC& O/S Installation1. Connect the power to 12V DC power supply to 3 pins Terminal block (Phoenix Type)2. Press the power

142-3 Driver InstallationThe PPC comes with a I931 User’s Manual and Driver CD that contains most of the drivers andutilities of your needs.a) Followi

15Chapter 3 Driver Installation3-1 Touch Driver InstallationHMI series default is Premier Touch. The touchscreen system consists of a touchscre

16Step.2 Enter “General” function and choose the language you need.Step.3 Correct 4 point locations on screen with the Panel. Screen display as follow

17Step.4 Play “Yes” to continue if 4 points calibration test is fine and finish the test3-2CAN BUS Driver InstallationHMI Series support 2 channels CA

18 Step2. Enter CAN BUS Folder. Install “setup.msi”. Then finish the installation.3-3Brightness AdjustmentIn our new product – 10.1” Panel PC, th

19Chapter 4 HMI series Panel PC Mounting GuideThe Panel PC is suitable for most of the industrial/commercial application, by anykind of mounting appro

2FCC StatementThis device complies with part 15 FCC rules. Operation is subject tothe following two conditions： This device may not cause harmful int

20Panel PC SizeVESA Mount Dimension5.7”75 x 75 mm7”75 x 75 mm10.1”75 x 75 mm

214-2 Panel Mount (Clip Design):-Panel is aligned with the same height of the front of open frame metalhousing.-Touch/Glass is higher than Open frame

22Panel mount (6mm Font Bezel)P a n e l P C S i z eMounting kit (pcs)5.7”47”410.1”8

23KNOWN ISSUES1. There might be some image noises displayed at the time of PC boot andWindows startup.2. When using an “external display” as CRT or LC

24NOTICES1. The Operation Systems we currently support are Windows XP and XP Embedded.When installing driver, please make sure you’re using

3Copyright NoticeALL RIGHTS RESERVED. No part of this document may be reproduced, copied,translated, or transmitted in any form or by any means, elect

4Check ListBefore using this BOX PC, please make sure that all the items listed below arepresent in your package 1 x HMI Series PPC unit 1 x Driver

5Safety Precautions Warning!Always completely disconnect the power cord from your chassiswhenever you work with the hardware. Do not make connections

6Safety and Warranty1. Please read these safety instructions carefully.2. Please keep this user's manual for later reference.3. Please disconnect

7Revision HistoryVersionDateNoteAuthor0.82010/9/8 First VersionCage Hsu1.02010/9/21 Revise Brightness ControlCage Hsu

8ContentsChapter 1 GENERAL INFORMATION......91-1 Introduction ...

9Chapter 1 GENERAL INFORMATION1-1 IntroductionThe Z5xx series Panel PC is high performance, low power PC with Intel® US15W XLChipset combin